Patio Heater Lighting Instructions

First, reset the propane regulator:

 Step 1

Turn the gas control on your patio heater or fire pit to the OFF position. Turn the shutoff valve on the propane tank to the OFF position by turning rotating the valve in a clockwise direction until it is fully closed.

 Step 2

Disconnect the regulator from the propane tank shutoff valve by twisting the knurled mounting knob in a counterclockwise direction. The regulator should now simply pull away from the propane tank valve.

 Step 3

Re-attach the regulator to the propane tank shutoff valve by threading the mounting knob back onto the valve. Screw the mounting knob in the clockwise direction until it is tight. Hand tighten only, do not use tools.

Lighting procedure:

1. Patio Heater Burner Valve Control Knob must be in the “OFF” position

2. Connect propane cylinder (See manual)

3. Slowly open the valve on the propane tank

4. Push and turn the burner control knob  to the start position

5. Continue to push in the burner control knob **Note: For initial start or after any cylinder change, hold burner control Knob IN for 10-15 seconds to purge air from gas lines before proceeding.

6. Press the igniter button repeatedly to light the burner

7. Once the burner is lit, continue to push the burner control knob for 10-15 seconds to activate the thermocouple

8. If ignition does not occur in 30 seconds push and turn the burner control knob to “OFF”

   wait 5 minutes and repeat the lighting procedure

9. Turn the burner control knob to adjust the flame height